|
|
|
|
|
This instruction sets the mode of subsequent OBCA operations to m.
Valid mode numbers are:
m=0 OBCA disabled [D>=9]
m=1 Measure input frequency with 0.1S timebase [D>=9]
m=2 Measure input frequency with 1S timebase [D>=9]
m=3 Measure input frequency with 10S timebase [D>=9]
m=4 totalizing counter (See note 2 below)
Note 1. This instruction modifies UV
Note 2. Mode 4 is not available in MMi99 Firmware versions before 3.22 or SL99 firmware versions before 3.41
Dialect exclusions: Not available in dialects before 9. Not available on SPLat controllers that do not have OBCA support (please check the documentation for your specific board and firmware version).
If you are using the MMi200 please click here for information on a restriction on using this instruction.
|
|
|