Tech Support: Getting connected (In Control)

Tech Support: Getting connected

Keith asked:

I have recently purchased a MMi202 and am trying to connect the board to my PC. I have checked the following- The MMi202 board has power. The serial cable is straight through (used a multimeter to check pin to pin). Tried to connect to board from 2 separate computers.

After clicking on the connect button of the Module window the display changes to Disc/Run/Stop display for a few seconds and then returns to the connect button display.

Any suggestions on how to proceed. Thanks.

Hi Keith,

People do occasionally stumble on this one.

The Interactive Training Course, lesson 5, contains a quite detailed guide on getting connected. You will find it on your CD in folder "Interactive training course". You can also run the course online.

Tags:

Posted on September 12, 2007 12:19 PM | Permalink

TrackBack

TrackBack URL for this entry:
http://www.splatco.com/cgi-sys/cgiwrap/microcon/managed-mt/mt-tb.cgi/73

Post a comment

(If you haven't left a comment here before, you may need to be approved by the site owner before your comment will appear. Until then, it won't appear on the entry. Thanks for waiting.)

Name:

Email Address:

URL:

Remember personal info?

Comments: (you may use HTML tags for style)

Enter the security code shown above:

About

This page contains a single entry from the blog posted on September 12, 2007 12:19 PM.

The previous post in this blog was Tech Support: Time interval measurement.

The next post in this blog is Tech Support: Non-volatile memory.

Many more can be found on the main index page or by looking through the archives.

In Control

About embedded electronic control systems. David Gibson, SPLat Controls