Tech Support: 5V analog inputs (In Control)

« Tech Support: What dialect do I have? | Main | Tech Support: SuperTimers »

Tech Support: 5V analog inputs

George asked:

I'm setting MMi02 up to read 0-5V Pressure Transducers. I gather from SKB that no jumpers are required at all on the analogue input configuration pins for 0-5V Mode. Would you please confirm this?

When programming for 0 - 5V does 10 bit range then refer to 5V equ 1.0 or do I still have to base the maths based on 10V equ 1.0? It's not clear to me from SKB.

Yes, leaving the jumper out gives you 0-5V range. An fAnIn will give a result of 1.0 for 5V.

TrackBack

TrackBack URL for this entry:
http://www.splatco.com/cgi-sys/cgiwrap/microcon/managed-mt/mt-tb.cgi/77

Post a comment

(If you haven't left a comment here before, you may need to be approved by the site owner before your comment will appear. Until then, it won't appear on the entry. Thanks for waiting.)

Name:

Email Address:

URL:

Remember personal info?

Comments: (you may use HTML tags for style)

Enter the security code shown above:

Search

About

This page contains a single entry from the blog posted on September 28, 2007 3:54 PM.

The previous post in this blog was Tech Support: What dialect do I have?.

The next post in this blog is Tech Support: SuperTimers.

Many more can be found on the main index page or by looking through the archives.

Subscribe to this blog's feed
[What is this?]

This weblog is licensed under a Creative Commons License.

In Control

About embedded electronic control systems. David Gibson, SPLat Controls